OPEN
I-40 is open on the Waynesville to the Tennessee Line (the Gorge, North Carolina side) segment with no closures or restrictions posted.
Last updated at: NOV 20, 2026, 6:29 AM EST · DriveNC and TDOT SmartWay
There are no chain laws on I-40 through the Pigeon River Gorge. North Carolina and Tennessee post restrictions, advisories, and closures instead, and the standing restriction today is one lane each way at 35 mph from Exit 7 to Exit 447.
North Carolina and Tennessee do not run this corridor like a western mountain pass. There is no chain control system on I-40 through the Pigeon River Gorge. There are no chain laws, no chain tiers, and no traction checkpoints to explain or to wait at. Do not look for them here, and do not bring chains expecting a posted chain requirement for this stretch.
Instead, both states post restrictions, advisories, and closures. That is the system this page reports. North Carolina posts through DriveNC, run by NCDOT. Tennessee posts through TDOT SmartWay. Each state posts for its own side of the gorge, and a gorge trip crosses both, so this page gathers both sets of posts for this corridor in one place, in the order you will drive them.
A restriction is a rule that limits how or what you can drive through a posted section. In the gorge today, the standing restriction every driver meets is the work zone pattern itself: one lane each way at 35 mph over about 12 miles, from Exit 7 in North Carolina to Exit 447 in Tennessee. Other restrictions are posted as conditions require, and they can include lane closures for rockfall or repair work, speed reductions, width or weight limits in a work zone, and temporary holds while a crash is cleared.
An advisory is a warning that conditions are changing or hazardous, without a full closure. Fog advisories, heavy rain and flood warnings, winter weather advisories, and crash delay notices all appear in this form. An advisory means slow down, expect delays, and check again before you leave. In the gorge, advisories deserve to be taken seriously, because fog, rain, and crashes are the three causes that most often turn a slow drive into a stopped one.
A closure is a full stop. When either state closes the gorge, through traffic uses the detour via I-26 to I-81, which adds about an hour. Closures here have followed rockslides, flooding, washouts, and major crashes. When this page says closed, it means the through lanes in the gorge are closed, not merely slow.
Truck and oversize rules for this corridor are set and published by NCDOT for North Carolina and by TDOT for Tennessee. This site reports those rules as published and does not create its own limits.
As published by the states, truck drivers should expect the posted 35 mph limit through the one lane section, lane and width constraints that come with a barrier separated work zone, and any temporary truck guidance posted during rockfall work, flooding, or crash clearance. Because the gorge has almost no shoulders and only one lane each way for now, a posted truck restriction in the gorge affects all traffic behind it, and this page will state the affected direction and section plainly when a restriction is active.
Oversize and overweight loads must follow the permit and routing rules published by the state they are traveling in, and loads that cannot meet a posted work zone width or weight limit must not enter the gorge section until the restriction lifts or a permitted alternate route is issued by the state. If you run oversize or overweight, confirm your permit and route with NCDOT on the North Carolina side and TDOT on the Tennessee side before you leave, and check this page on the day of travel for temporary restrictions that were posted after your permit was issued.
If no truck or oversize restriction is listed on this page, that means neither state is posting one for the gorge at the time shown. It does not change the standing 35 mph work zone limit, which applies to all vehicles.
I-40 gorge closures, rockslide and flood alerts, and Smoky Mountain weather between Asheville and Knoxville, straight to your inbox. Unsubscribe at any time.
No. Neither state runs a chain control system on this corridor. There are no chain laws, no chain tiers, and no traction checkpoints here. Both states post restrictions, advisories, and closures instead, and that is the system this page reports.
One lane each way at 35 mph over about 12 miles, from Exit 7 in North Carolina to Exit 447 in Tennessee. It is the work zone pattern for the Hurricane Helene rebuild, it applies to all vehicles, and it is expected to remain the normal condition through late 2028.
A restriction is a posted rule that limits how or what you can drive through a section, like the 35 mph work zone limit or a width limit. An advisory is a warning that conditions are hazardous or changing, like fog or flood warnings, without a full closure. A closure is a full stop: when either state closes the gorge, through traffic uses the detour via I-26 to I-81.
They are set and published by NCDOT for North Carolina and TDOT for Tennessee, and this site reports them as published. Expect the posted 35 mph limit, the lane and width constraints of a barrier separated work zone, and any temporary truck guidance posted during rockfall work, flooding, or crash clearance. Oversize and overweight loads follow the permit and routing rules of the state they are in, and must not enter a section whose posted width or weight limit they cannot meet.
Slow down, expect delays, and check again before you leave. Advisories deserve to be taken seriously here, because fog, rain, and crashes are the three causes that most often turn a slow gorge drive into a stopped one.